netsh » ipsec » dynamic » show » rule

Microsoft Windows [Version 6.0.6001]
(C) Copyright 2006 Microsoft Corp.
c:\windows>netsh ipsec dynamic show rule ? Usage: rule [ [ type = ] (transport | tunnel) ] [ [ srcaddr = ] (ipv4 | ipv6 | ipv4-ipv4 | ipv6-ipv6 | dns | server) ] [ [ dstaddr = ] (ipv4 | ipv6 | ipv4-ipv4 | ipv6-ipv6 | dns | server) ] [ [ srcmask = ] (mask | prefix) ] [ [ dstmask = ] (mask | prefix) ] [ [ protocol = ] (ANY | ICMP | TCP | UDP | RAW | ) ] [ [ srcport = ] ] [ [ dstport = ] ] [ [ actioninbound = ] (permit | block | negotiate) ] [ [ actionoutbound = ] (permit | block | negotiate) ] [ [ resolvedns = ] (yes | no) ] Displays rule details from SPD. Parameters: Tag Value type -Type of rule to display, either transport or tunnel. srcaddr -Source ip address (ipv4 or ipv6), address range, dns name, or server type. dstaddr -Destination ip address (ipv4 or ipv6), address range, dns name, or server type. srcmask -Source address mask or a prefix of 1 through 32. dstmask -Destination address mask or a prefix of 1 through 32. protocol -Can be ANY, ICMP, TCP, UDP, RAW, or an integer. srcport -Source port. A value of 0 means any port. dstport -Destination port. A value of 0 means any port. actioninbound -Action for inbound packets. actionoutbound -Action for outbound packets. resolvedns -Value of 'yes' displays the resolved dns name. Remarks: 1. Default for the type parameter is 'transport'. 2. Server type can be WINS, DNS, DHCP or GATEWAY. 3. If source or destination address name is specified, only rules associated with that address are displayed. 4. If an address range is specified, the endpoints need to be specific addresses (not lists, or subnets) and of the same type (both should be v4 or both should be v6). Examples: 1. show rule - shows both transport and tunnel rules 2. show rule type=transport srcaddr=192.134.135.133 proto=TCP

NETSH / IPSEC / DYNAMIC / SHOW / RULE


Quick - Link:
netsh p2p pnrp cloud show pnrpmode
Displays PNRP mode configuration parameter.
netsh interface ipv6 add neighbors
Adds a neighbor address.
netsh interface tcp set global
Sets global TCP parameters.
netsh nap client reset configuration
Resets configuration.








Windows-10


... Windows 10 FAQ
... Windows 10 How To


Windows 10 How To


... Windows 11 How To
... Windows 10 FAQ



Displays rule details from SPD. / Windows Vista

HTTP: ... cmd/en/Windows_Vista/netsh/ipsec/dynamic/show/rule.htm
0.062
15459

Can I filter certain file types in the directory contents printing?

Help, Windows 10 Defender is turned off or Permanently Turn off? (on, Enable)

Repair bad sectors of hard drive with commands of the CMD on Windows 11, 10, ...!

Uninstall fonts from Windows-10 / 11 (remove, delete)?

Can I see the Folder network access under Windows 10 or 11?

Windows 10 slow startup of programs and high CPU load, what to do?



(0)