NETSH - Windows XP/2000

netsh » routing » ip » show » mfe

Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1986-2001 Microsoft Corp.
C:\WINDOWS>netsh routing ip show mfe ? Usage: show mfe [[grpaddr=] [grpmask=] [[srcaddr=] [srcmask=]] [[type=]active|negative|both] [[rr=]integer] Parameters: Tag Value grpaddr - The group IP address for the start of the range. grpmask - The subnet mask associated with the group IP address. srcaddr - The source IP address of the start of the range. srcmask - The subnet mask associated with the source IP address. type - One of the following values: active: Show active multicast forwarding entries (MFEs) only negative: Show negative MFEs only both: Show both active and negative MFEs (default) rr - The refresh rate in seconds. Remarks: Displays multicast forwarding entries. The information displayed for this command consists of: Field Description ----- ----------- Group - Group(s) to which the data is destined Source - Source(s) from which the data originated Prot - Multicast protocol that is enabled on the incoming interface In/Out Interface - The first line of an MFE displays the incoming interface The subsequent line(s) display the outgoing interfaces (one per line) UpstrmNbr/NHOP - The first line of an MFE displays the upstream neighbor on the incoming side The subequent line(s) display the next hop corresponding to each outgoing interface Examples: show mfe show mfe grpaddr=239.0.0.1 mask=255.255.255.255

NETSH / ROUTING / IP / SHOW / MFE

netsh routing ip show mfe - Windows 2000/XP - command Displays multicast forwarding entries / Windows 2000/XP
netsh, routing, ip, show, mfe, cmd, command, Windows, 2000/XP
Quick - Link:
netsh diag ping mail
Ping Outlook Express mail server.
netsh routing ip igmp show proxygrouptable
Shows IGMP hosts group table for an IGMP Proxy interface.
netsh interface ipv6 show teredo
Shows Teredo service state.
netsh routing ipx dump
Displays a configuration script.
netsh ras ip delete
Removes items from a table.
netsh interface help
Displays a list of commands.












Windows-10





Windows-10
HTTP: ... cmd/en/Windows_XP/netsh/routing/ip/show/mfe.htm

0.108

Kann ich x86 Anwendung bei einem x64 Prozessor einsetzen?

 /

Hide when run: commands, favorite cmd-s in Run-Command - Windows 10, 11, 8.1, 7!

 /

Komplettes Windows-7 Systemabbild zur PC-Wiederherstellung erstellen, aber wie?

 /

How to find Windows 10 Creators Update on my PC?

 /

How to manage blocked people and apps on Facebook.com?

 /

Wie kann man mehrere nicht aufeinander folgende Zeilen von Text in MS-Word markieren?

 /

Auto size Virtual Memory in Windows 10?

 /

IsMyLcdOK - The Pixel tester for Windows!

 /