C:\WINDOWS>HELP ARP
Displays and modifies the IP-to-Physical address translation tables
used by
address resolution protocol (ARP).

ARP -s inet_addr eth_addr [if_addr]
ARP -d inet_addr [if_addr]
ARP -a [inet_addr] [-N if_addr]

 -a            Displays current ARP entries by interrogating the
current
               protocol data.  If inet_addr is specified, the IP and
Physical
               addresses for only the specified computer are
displayed.  If
               more than one network interface uses ARP, entries for
each ARP
               table are displayed.
 -g            Same as -a.
 inet_addr     Specifies an internet address.
 -N if_addr    Displays the ARP entries for the network interface
specified
               by if_addr.
 -d            Deletes the host specified by inet_addr. inet_addr may
be
               wildcarded with * to delete all hosts.
 -s            Adds the host and associates the Internet address
inet_addr
               with the Physical address eth_addr.  The Physical
address is
               given as 6 hexadecimal bytes separated by hyphens. The
entry
               is permanent.
 eth_addr      Specifies a physical address.
 if_addr       If present, this specifies the Internet address of the
               interface whose address translation table should be
modified.
               If not present, the first applicable interface will be
used.
Example:
 > arp -s 157.55.85.212   00-aa-00-62-c6-09  .... Adds a static entry.
 > arp -a                                    .... Displays the arp
table.



C:\WINDOWS>CONVLOG /?




C:\WINDOWS>DEBUG /?

Runs Debug, a program testing and editing tool.

DEBUG [[drive:][path]filename [testfile-parameters]]

 [drive:][path]filename  Specifies the file you want to test.
 testfile-parameters     Specifies command-line information required
by
                         the file you want to test.

After Debug starts, type ? to display a list of debugging commands.