Tag Value property -Property name. value -Value that corresponds to the property.
Remarks: 1. Valid values for the properties are: ipsecdiagnostics - 0, 1, 2, 3, 4, 5, 6, 7 ikelogging - 0, 1 strongcrlcheck - 0, 1, 2 ipsecloginterval - 60 to 86400 sec ipsecexempt - 0, 1, 2, 3 bootmode - stateful, block, permit bootexemptions - none, "exemption#1 exemption#2 ... exemption#n" where the quoted string specifies a list of protocols and ports to always allow during boot mode in the following format: Protocol:SrcPort:DstPort:Direction where protocol is ICMP, TCP, UDP, RAW, or where direction is inbound or outbound 2. ipsecdiagnostics, ikelogging, ipsecloginterval, bootmode and bootexemptions options are provided for backward compatibility. Not valid for Windows Vista and later operating systems. 3. SrcPort and DstPort are only valid for TCP and UDP, with other protocols the format of the exemption is Protocol:Direction. 4. A port setting of 0 allows for traffic for any port. 5. ikelogging and strongcrlcheck are activated immediately; all other properties take effect on next boot.
Examples: 1. set config property=ipsecdiagnostics value=0 2. set config property=bootmode value=stateful 3. set config property=bootexemptions value=none 4. set config property=bootexemptions value="ICMP:inbound TCP:80:80:outbound"
NETSH / IPSEC / DYNAMIC / SET / CONFIG
netsh ipsec dynamic set config - Windows Vista - commandSets the IPsec configuration and boot time behavior. - Windows Vista netsh, ipsec, dynamic, set, config, cmd, command, Windows, Vista
