netsh » interface » ipv4 » add » address

Microsoft Windows [Version 6.1.7000]
(C) Copyright 2009 Microsoft Corp.
C:\Windows>netsh interface ipv4 add address ? Usage: add address [name=] [[address=][/ [[mask=]]] [[type=]unicast|anycast]] [[gateway=] [gwmetric=]] [[validlifetime=]|infinite] [[preferredlifetime=]|infinite] [[subinterface=]] [[store=]active|persistent] Parameters: Tag Value name - Interface name or index. address - IPv4 address to add, optionally followed by the subnet prefix length. mask - The IP subnet mask for the specified IP address. type - One of the following values: unicast: Adds a unicast address (default). anycast: Adds an anycast address. gateway - The IPv4 address of a default gateway to add. gwmetric - The metric to the default gateway. validlifetime - Lifetime over which the address/route is valid. The default value is infinite. preferredlifetime - Lifetime over which the address/route is preferred. The default value is infinite. subinterface - LUID of subinterface on which the default gateway exists. This parameter is only needed on interfaces with multiple subinterfaces. store - One of the following values: active: Address will disappear on next boot. persistent: Address will be persistent. This is the default. Remarks: Adds static IP addresses and default gateways to an interface. If DHCP is enabled on the interface, it will be disabled. Examples: add address "Local Area Connection" 10.0.0.2 255.0.0.0 add address "Local Area Connection" gateway=10.0.0.3 gwmetric=2 The first command adds a static IP address of 10.0.0.2 with a subnet mask of 255.0.0.0 to the Local Area Connection interface. The second command adds the IP address of 10.0.0.3 as a second default gateway for this interface with a gateway metric of 2.