Microsoft Windows [Version 6.1.7000 ](C) Copyright 2009 Microsoft Corp. C :\Windows>netsh ipsec dynamic set config ?
Usage :
config [ property = ] (ipsecdiagnostics | ipsecexempt | ipsecloginterval |
ikelogging | strongcrlcheck | bootmode | bootexemptions) ]
[ value = ] | | ]
Configures the parameters for IPsec.
Parameters:
Tag Value
property -Property name.
value -Value that corresponds to the property.
Remarks: 1. Valid values for the properties are:
ipsecdiagnostics - 0, 1, 2, 3, 4, 5, 6, 7
ikelogging - 0, 1
strongcrlcheck - 0, 1, 2
ipsecloginterval - 60 to 86400 sec
ipsecexempt - 0, 1, 2, 3
bootmode - stateful, block, permit
bootexemptions - none, "exemption#1 exemption#2 ... exemption#n"
where the quoted string specifies a list of
protocols and ports to always allow during
boot mode in the following format:
Protocol:SrcPort:DstPort:Direction
where protocol is ICMP, TCP, UDP,
RAW, or
where direction is inbound or outbound
2. ipsecdiagnostics, ikelogging, ipsecloginterval, bootmode and
bootexemptions options are provided for backward compatibility.
Not valid for Windows Vista and later operating systems.
3. SrcPort and DstPort are only valid for TCP and UDP, with other
protocols the format of the exemption is Protocol:Direction.
4. A port setting of 0 allows for traffic for any port.
5. ikelogging and strongcrlcheck are activated immediately;
all other properties take effect on next boot.
Examples: 1. set config property=ipsecdiagnostics value=0
2. set config property=bootmode value=stateful
3. set config property=bootexemptions value=none
4. set config property=bootexemptions
value="ICMP:inbound TCP:80:80:outbound"
|
